Gutter Installation Procedures

Call Us


Call Us

  1. Remove old gutters, downspouts, flashings, haul away.
  2. Inspect all fascia boards, replace rotten boards if necessary at an additional charge.
  3. Determine the number of downspouts needed and the proper locations of the downspouts.
  4. Extrude heavy gauge 0.032 seamless 5" aluminum gutter system to exact lengths, in the brand and color of your choice. 6" sizes available at an additional charge.
  5. All gutters are pitched approximately 1h inch per 40 feet of gutter to run toward downspouts.
  6. It may be necessary to add, subtract or change downspouts to oversized 3" x 4" size.
  7. Install heavy gauge flashing where possible.
  8. Install aluminum omni gutter hangers every 24 inches or closer with screw shank nails thru hanger, flashing, fascia, and into rafter where applicable.
  9. All downspouts are installed with 2 aluminum straps per 12 feet.
  10. We seal all mitres, drop outlets, endcaps, with synthetic rubber resin amorphous silica sealant, the best available.
  11. All parts of installation are secured with aluminum screws.
  12. Customer’s premises are left clean.
  13. Wilson Installations Inc. will supply a waiver or lien upon request.
  14. Wilson Installations Inc. will supply a certificate of insurance upon request.
  15. Wilson Installations Inc. stands behind all of its installations with a 10-year guarantee, unless otherwise indicated in your proposal.

We install products from these fine manufactruers:


Wilson Installations, Inc. | 18-5 East Dundee Rd., Suite 300 | Barrington, Illinois 60010 |Phone: (847) 991-4441